Product code: 
IP-G14-F7988-HV
PANEL 14 HELIUM

14 dBi Tuned Directional Antenna (EU 868)

This 14 dBi directional antenna is designed for long-range connections in LoRaWAN, Helium and IoT systems operating in the European 868 MHz band.

It is optimized for maximum forward signal concentration and minimal energy loss in unwanted directions.

Very long-range performance

With a high gain of 14 dBi, this antenna enables communication over very long distances, especially in environments with good radio visibility.

electrical

Frequency (min)
790MHz
Frequency (max)
880MHz
Gain
  1. 14dBi
VSWR (max)
2.00:1
Polarization
Horizontal or Vertical
Half Power Beam Width (-3dB) - horizontal
  1. 30°
Half Power Beam Width (-3dB) - vertical
  1. 30°
FBR (Front/Back Ratio)
>20dB
XPD (Cross Polarization Discrimination)
>21dB
Max Composite Power
500W
DC Ground
yes
Impedance
50Ω

mechanical

Connector
N female
Mounting Diameter
ø 38…51mm
Dimensions (excl. mount)
504x504x30
Weight (incl. mount)
2.80kg

enviromental

Enviroment
Outdoor
Windload
160km/h
IP Rating
IP67
Temperature
-40°C ... 80°C

compliance

14 dBi 868 MHz directional panel antenna for LoRaWAN and Helium (EU868)
Instalation tips: 

Fine adjustment of the antenna ensures the correct propagation of radio signals. Proper installation of the mast, antenna and cable provide a stable and proper operation of the antenna installation.

  • Level mast or boom using a bubble leveler.
  • Assemble the antenna mount as on drawing.
  • Level mast or boom using a bubble leveler.
  • Assemble the antenna mount as on drawing.
  • Mount antenna on the mast.
  • Level the mast or boom, check antenna vertical position.
  • Vent holes should be located at the bottom of the antenna.
  • Screw the antenna to the mast, leaving slack in the adjustment of direction and inclination.
  • Determine the direction and inclination.
  • Finally tighten the mounting screws.
  • Connect cable and insulate antenna connector.
  • Fasten cable to the mast or boom.
  • It is worth to note achieved link parameters.
  • Nuts securing the antenna to the holder should be tightened with a torque wrench with a force of 17-18Nm.





  
  




  
      
  
  04/20/2026 - 06:23