код продукта: 
IH-G0607-F2456-V-M
HORIZON 4X4 MIMO DUAL-BAND

The antenna has two beams of radiation. One in front of about 6-7 dBi and the second beam is lifted up by 10% with about 6-7 dBi gain. Modern warehouses roofing and ceiling are made of metal sheets or concrete, which greatly simplifies bouncing radio waves. One of the beams of radiation in these antennas cover the area of the hall "in front of" making it difficult for the propagation of the signal through obstacles or storage racks loaded with goods. The task of the second beam after reflection from the ceiling, is to cover the dead space between the obstacles (shelves). The antenna is specially designed to work in such conditions.

Электрические

Диапазоны частот
  1. 2400 - 2500
  2. 5200 - 5800
Частота (мин)
2 400MHz
Частота (макс)
5 800MHz
Коэффициент усиления
  1. 6dBi
  2. 7dBi
КСВ (макс)
1.40:1
Поляризация
Вертикальная
в горизонтальной плоскости (-3дБ)
  1. 360°
в вертикальной плоскости (-3дБ)
  1. 30°
  2. 20°
Port to Port Isolation:
>20dB
Максимальная составная мощность
2W
Сокращенный для DC
нет
Импеданс
50Ω

Механические

Разъем
N female
Монтажный диаметр
ø 38…51mm
Размеры (без крепления)
290X80
Вес (с креплением)
1.21kg

Окружающая среда

Размещение
наружное
Ветровая нагрузка
130km/h
Степень защиты IP
IP65
Temperature
-40°C ... 80°C

Совместимость

Instalation tips: 

Fine adjustment of the antenna ensures the correct propagation of radio signals. Proper installation of the mast, antenna and cable provide a stable and proper operation of the antenna installation.

Horizon series antennas can be mounted under the ceiling (vice versa) with the cable or jack upside down

  • Level mast or boom using a bubble leveler.
  • Assemble the antenna mount as on drawing.
  • Level mast or boom using a bubble leveler.
  • Assemble the antenna mount as on drawing.
  • Mount antenna on the mast.
  • Level the mast or boom, check antenna vertical position.
  • Vent holes should be located at the bottom of the antenna.
  • Screw the antenna to the mast, leaving slack in the adjustment of direction and inclination.
  • Determine the direction and inclination.
  • Finally tighten the mounting screws.
  • Connect cable and insulate antenna connector.
  • Fasten cable to the mast or boom.
  • It is worth to note achieved link parameters.
05/15/2019 - 09:05